Connector general features:
- Insulation piercing is carried out on the main and tap conductors simultaneously.
- The dielectric strength in water is greater than 6kV.
- The tightening screws are potential free.
- Tightening efficiency is ensured by shear head screws.
- ConnectorsK445,K354andK446arefittedwithayellowshearheadindicatorthatdisappearswhenheadissheared- off, being a clear visual confirmation of good tightening from ground level. It increases head height by 10 mm.
This connector meets the criteria of the NF C 33-020 and EN 50-483 standards.
Connector end cap:
- The connector end cap is flexible so that to feel good tap conductor insertion simply by hand.
- It is carrying membranes instead of grease, granting watertightness around tap conductor end on long term basis.
- It is glued on connector body so that to avoid eventual loss during handling, installation and environment (wind, bad
weather...).
- It can be equipped with a hard end cap, gripping and covering so, in case rigid cover is required.
Technical specification
Dimensions | |
Main Cable Line: | 35-70mm² |
Branch Cable Line: | 6-35mm² |
Norminal Current: | |
Piercing Depth: | |
Features | |
Bolt: | M8*70 |
Mechnical | |
Tightening Torque: | 20Nm |
